Metal Roof Power Mast Boot

The flashco weatherhead flashing is constructed with lead and solder and has a lifetime warranty.

Metal roof power mast boot.

You need an edpm rubber pipe boot of the correct size for the mast. Close the base around pipe so that the door faces downhill. All good roofers know lead is the 1 choice for a quality job done right and nobody does it better than flashco. Roofing systems are lasting longer and it only makes sense your flashings should too.

Mast boot for metal mast 9560 oval mast section. The new split boot 1 piece design eliminates the guess work of cutting and sealing standard flashing and the need to unhook power lines saving you time and money. Seal the door edges with m1 sealant or solder closed. Add an additional bead of m1 at the metal edge and over nail tops.

Sometimes you ll see a through the roof service mast that appears to be leaning from tension in the overhead service drop conductors. Slip on the metal retro spin flashing base. Hi i am going to lath strip and cover my reroofing over existing roof with power mast 1 10 2007 within the flashing discussion of the residential metal roofing forum. The typical service mast consists of 2 inch rigid metal conduit.

Mast boot to fit metal mast 9560 oval mast section 9 5 x 6 0 and special pearson cast deck collar. Hard molded white pvc mast boot is 2 3 4 high x 11 1 2 long. As used on pearson 40. Ive done countless service upgrades drilling through roofs and mounting the standard flashing but the problem is they have all been shingle roofs.

Be sure m1 sealant creates a seal to the underlayment. Nail flashing along upper area. The emc master flash is designed to seal around an electrical service mast or pipe in residential applications. The new mast must run through the roof old one wasnt and the roof is corrugated metal with 7 gaps between ribs.

Mast boot for metal mast 11070 oval section. This can be repaired by adding a brace tie back or guy wire supports. When you roof your way over to the mast you will hopefully find that the mast is in the middle of a panel not on or near a rib in fact you may want to plan your first panel so that your mast is centered in a subsequent panel. This adjustable rubber pipe boot flashing simplifies the replacement of deteriorating flashings around electrical masts on shingle roofing.