Metal Flashing At Bottom Of Siding

I ve got brick veneer halfway up the side of my house.

Metal flashing at bottom of siding.

Flashing is a strip of metal usually aluminum about 8 inches long and bent at 90 degrees with each side at least 5 inches wide. The water runs down the siding and at the bottom of the first row of vinyl siding it drips off and contacts the metal flashing as it runs across the top of the fascia board. Posted on april 23 2018 by lumberjack news. The purpose of metal flashing behind the butt joint is to protect against water intrusion and to protect the housewrap from uv degradation ojeda says.

Kickout flashing installs just like standard step flashing except that half of the kickout flashing hangs over the edge of the roof. The solution to rotting sidewalls is a small piece of bent metal called a kickout flashing at roofing suppliers which simply directs all that water away from the wall. Details like this risk rot and insect damage to the structure. On a wall to be covered with wood cement board vinyl or metal.

Z flashing is required over horizontal wood trim pieces typically seen above doors or windows as well as decorative trim bands. The water then runs off the flashing because it can t go up the flashing as it extends up behind the siding. It should have a drip edge that hangs below the sill plate with the bottom edge at least 8 inches above grade. The wall system begins with flashing at the bottom of the wall which collects water that drains down the wall and kicks it out at the base.

Metal flashing at bottom of siding top of brick veneer. Maybe in this case the flashing extends upwards behind the building siding forming a zee shape that might reduce this risk. Metal or pvc flashing can be used. The metal flashing placed on wall top slopes back towards the building directing water inside the structure.